Recent content by Powerstroked

Well the ICP and connector were the problem. Everything is running well.

I drove it home tonight, ICP unplugged was doing 65-70 with no issues. CEL is on, I am sure that has something to do with the ICP. I have a harness in route, so lets hope this is the last of my recent bad luck with this truck.

Thank you for all the replies. I will provide more feedback once I get the truck back to the house and work on it.

So I think I might have this figured out. I found the adapter for my coolant bypass filter leaking near the ICP connector. I replaced the ICP two weeks ago, but if I disconnect the ICP it starts and does not die. I have never replaced the connector, but it seems I may have a problem...

Any info on cam and crank sensor replacement? I might just jump on this as it seems logical, I have no access to a scan tool and I don't trust the local Ford dealer. Perhaps someone can suggest a good place near the Wilkes barre area of PA, just moved here.

I appreciate all the post thus far, I do put an anti-gel additive during each fill up, The fuel pressure does not falter at all during the start stop process. It is like a key off scenario... everything stays on except the beast under the hood.

Familiar Problem With as many post that I seen on this I would of thought that someone could say yes... this did happen to me.

IPR only has 8-10k on it (replaced when I did new injector orings and HP oil rail seals). Truck runs great when running.

So I have seen this post on more forums than I care to count and none lead to an actual repair. This morning on the way to work my truck was running great and just randomly stalled. I pulled over to the side of the interstate and it started right up and ran great again. About 2 miles down the...

Gauge That is possible, it was new though when I installed it. I purchased a cheap one though through Glow Shift.

There is a pressure adjustment, I have adjusted but it does not effect measured pressure.

AD This is a replacement pump from AD with less than 3 hours on it, I have the same symptoms as the previous pump.

HFCM No, I have the factory HFCM bypassed with the installation of the AD II 165

Ok, I have had it with this problem. In December I started to have hesitation and idle problems at startup, accompanied by some surging at stop signs. I began with installing a fuel pressure gauge that showed a fuel pressure problem. First thing, I was on the line with Air Dog, replaced the...

So to wrap this thread up, it ended up as injector o-rings. They looked good visually from an installed aspect. Was doing hpop seals and decided to go ahead and replace the o-rings on the injectors to be safe, as I pulled them apart I found 4 of the 8 with bad o-rings, and 2 more starting to...