Recent content by Dieselfever

Can you get pics and specs for me?

The actually will work with a stock turbo, guy local to me bought the engine out of my old pulling truck and stuck those 400/200's into an otherwise stock OBS. :thumbup: It did alright, GLSW Dennis.

Okay, the rear on my Excursion isn't blowing cold either. I found out the rear uses an expansion valve not an orifice tube, I recovered the system and vacuumed it to leak test it, then recharged it. Everything thing seems to be working correctly, the line going into the rear evaporator from the...

Mine is an 02 and has Swamps 200/30's, Hydra with Swamps tuning, regulated return, 4" exhaust and built trans. I have yet to put my 38R and bellowed uppipes on but I love the set up other than the stock turbo surges in higher settings, which is why I got the drop in. If you don't plan on going...

I know 02 pickups will run the fog lights solo, I just figured the excursions would too

Also mine had the auto dimming rear view mirror, but it doesn't work and most of the glass is dark. Where can I get a new one?

For Late 99-03 7.3? I am interested in the Non EBPV pedestal and up pipes

Mine is tan also, it's the leather similar to a Lariat interior. PM me how much you want for them, pics and where they're coming from

My 02 Excursion is a limited with leather seats and the driver's side is memory, both of my front seats are getting rough, what it's the best option to replace or upgrade just the front two seats? Secondly, it has Factory fog lights, I was thinking the fog lights should come on when the marker...

The rear system is T'd into the front, the discharge line from the condenser splits before the orifice tube and goes to the rear evaporator, which has its own orifice tube.

Pm sent

I think it is the default. I made sure it was set on factory pyro, I even selected H&S pyro and selected back to factory to make certain. The new sensor and the old sensor ohm the same and I have 5v ref and continuity on the return wire, So I don't think it's wiring

I have a truck that I just did new lifters on, put it back together and everything is fine EXCEPT the reading for Pyro1 only reads 92 degrees all the time. Before doing the work it was working correctly. I have checked the user settings in the Mini maxx and it is set to use the factory pyro...

I just did a truck where all the rocker tips were so worn that the end wouldn't swivel, I didn't realize how bad they were until I got the new ones and compared then took one of the old ones apart and it was really obvious then

Perfect, that's how I figured on doing it. I've done 6.0's plenty and these are close to the same size I figure