Recent content by kingbilly68

It was the harness. It was partially unplugged inside the valve cover. 50 cent mod...

Ok. That was my next question. Thanks

Would you go ahead and replace both sides? Also, I’m thinking I might as well replace glow plugs while I’m in there. 01 with 200,000 miles and as far as I know they’re original.

Cheaper than an injector. I’ll start there. Thanks guys.

I checked the uvch plugs. I haven’t pulled the valve cover.

These are after replacing the idm. I buzz tested today and #7 was very weak.

Ok. Thanks guys

Any reason to go with higher voltage with stock injectors? Sent from my iPad using Tapatalk

Got it scanned today. Idm code. Anything I should check before I order one? Sent from my iPad using Tapatalk

I’ll see if I can find someone near me with ae. If not, hopefully a local shop has a snap on scanner.

Hey guys, Got a new issue. Rough idle. Not romping. Misses on acceleration with a cel. Drive for 30 minutes or so and it clears up usually. Only way I can pull codes is torque app and it shows no codes. No unusual or excessive smoke. Any advice is appreciated. Had it scanned at Oreilly and auto...

Sold Sent from my iPad using Tapatalk

Got it figured out. 42 pin connector

Motorcraft icp sensor. Can’t return because I installed it. My loss, your gain. $80 shipped. Pm me for more information

Got it figured out. Loose cable on passenger side. I feel pretty dumb... thanks for the help everyone.