Recent content by PSDSeven.3

Can I get a price on 2004 xlt super duty headlights and turn signals? Both sides. Thank you

Never mind everything just showed up.

Can I get a tracking # for Q321106, if it has been shipped yet? Thanks

Paypal sent

Can i get a quote for my pile of parts please? Thanks Front leaf front bolt (2)...........w704660-5426 front leaf front nut (2).............n807659-s427 front leaf rear shackle bolt (2)..w500593-s439 these should be leaf to shackle front leaf rear shackle nut (2)...n800237-s301 x code front...

Got the mirrors, thanks and you have a pm

Interested in the mirrors and hardware and the ash tray if it is gray. Price to 58703

Aluminum one to 58703

Could I get a quote for two of each of the following: OBS rear leaf shackle.......E0TZ-5776-A Front bolt for rear leaf.....W706828-S426 Front nut for rear leaf......W707678-S441 Rear bolt for rear leaf.......W500593-S439 Rear nut for rear leaf........N620485-S441 V code front...

I think it is supposed to be within an inch of the top, check how much oil you have in the engine. If it gets low enough the truck will not run, though I am not sure how much you would have to lose, probably a gallon or two.

Here you go http://powerstrokearmy.com/forums/showthread.php?t=27143 and another read about transmission choice, even though it was about 7.3's it can still apply since it has gone kind of off topic and now just about covers every transmission ever made apparently...

I never said put it in the valve cores, but if it is in the tires and you check the air it will get into the core. Now maybe it is finer than the beads and won't get stuck in the core and if that is the case then it would be better.

I have that in the tires on my work truck and it is ok. Only problems are when you check the air in the tires and the beads get stuck in the valve core and you have to pull the core to clear it. It also doesn't seem to help at 70 mph+ when the rims are packed with mud, which is about 99.9% of...

I don't see why Ford didn't do this from the factory. On my work truck, which is a '12 5500 all you have to do is put it in park, hit on and then set and it goes to 900 rpm. Then use resume and it will go up to 2000 rpm. My old work truck with a 5.9 was similar. It is rather nice when idling...

Welcome, Bob