Recent content by speedkills502

S
obs d66 turbo

Did you sale the d66?
- speedkills502
- Post #4
- May 19, 2017
- Forum: Aftermarket Performance
S
coolant leak

I would also say the upper hose. If you drain the rad. I would replace both the upper and lower hose on the block side. The ford hoses are new design with one end dual sealed the hose will have one black end and one white.
- speedkills502
- Post #9
- Nov 14, 2013
- Forum: 6.4 Tech
S
Balance rates on injectors

I could be wrong but the fuel trim readings should only be used for idle and lower rpms. Once the rpms increase the readings want be accurate and 10% under are over is normal injector are engine concern.
- speedkills502
- Post #11
- Sep 16, 2013
- Forum: 6.4 Aftermarket
S
downpipe

If you loosen the cab bolts you can rack it side to side with your body weight at the cab corners. And if get under the truck you can move the cab back with a four foot pry bar off the frame to the body supports.
- speedkills502
- Post #24
- Jun 17, 2013
- Forum: 6.4 Aftermarket
S
BD egr delete and elbow

Thanks for the offer but I ordered the No Limit set up this week Thanks to bigrpowr.
- speedkills502
- Post #10
- Jun 7, 2013
- Forum: 6.4 Aftermarket
S
BD egr delete and elbow

OK so not a good company to buy from point taken, glad some one let me know I will wait till I can get the no limit setup.
- speedkills502
- Post #3
- Jun 2, 2013
- Forum: 6.4 Aftermarket
S
BD egr delete and elbow

I know the no limit cac tube and elbow is the one of the best setups. But is any one running a bd elbow, does it flow good and make good power. The elbow looks good and the price is low on them bd is discontinuing them.
- speedkills502
- Thread
- Jun 2, 2013
- Replies: 11
- Forum: 6.4 Aftermarket
S
High EGTs

Thanks guys just checking that is good to hear. Would you run the 300 tune with no head studs. I don't run it hard if it is not warm at 180 are higher.
- speedkills502
- Post #7
- May 27, 2013
- Forum: 6.4 Aftermarket
S
High EGTs

Ok I never post, just read most of the time. I have a 2010 F250 H&S,S&B,5" sight pipe. I do not run it hard a lot just some quick bast and a burnout sometimes but it is a xl :shrug: single track it spins at wide open throttle if it is not above 45mph. I run it on the 250 tune and have it set to...
- speedkills502
- Thread
- May 26, 2013
- Replies: 8
- Forum: 6.4 Aftermarket