Haven't been on here in a while but looked at this old post and found a pic of what I came up with for this setup. I'll look for some more pic of intake I made as well
Anyone have any pictures of a single charger mount off of the old a/c compressor bracket or anything. I cut open the intake plemuns and built my own intake runner that covers the whole valley, so no room for charger. I think i have an idea just wanted to see some pics if i could. Thanks
aftermarket rods and studs would not be a waste of money.( sorry if i came across as just leaving the factory rods and adding studs) every engine is different. i run 400/400's in my sled truck with carrillo's, main studs, and a 1.75" fill. balanced the crank and checked alignment on mains...
rods and studs will be just fine with that setup if your goals for more hp in future do the hard block now and be done with it pry 1.5" or so from the deck would be ok dont waste money on a girdle