Search results
-
11-14 Turbo Boost Problem, Maybe want to do 15 Upgrade,
I have a 2012 6.7 here that doesn't make any boost, zero. It's not setting any codes yet, not even a low boost code. So I'm not sure exactly what the problem is, I checked the MAP and it had some build up on it, but not the problem, I checked the EBPS and didn't find anything plugged... -
Bye Bye EZ Lynk
Keep in mind that the EPA is self-funded, that means all their operating funds and payroll comes from fines and fees.- Gary
- Post #9
- Forum: 2017+ 6.7 Aluminum Super Duty
-
-
7.3 Engine R&R With 6 Speed
So the engine will come out with the trans still in the truck? I was thinking the trans had to come out before the engine could come out -
7.3 Engine R&R With 6 Speed
Will the engine come out with the trans still in? For some reason I think I remember it won't. I've done plenty of 4R100's but never a 6 speed. -
Intermittent no start
If it's a no-crank/no-start, try disconnecting the fan at the connector in front of the fuel filter housing. I faulty fan clutch can cause that no-crank condition. -
2006 6.0 injector knock?
It sounds to me like a cracked injector nozzle, it'll dump so much fuel they are hydro-locking which is making the noise. When they are dumping fuel like that you can "taste" the diesel fuel when you can near the exhaust. If the nozzle is cracked you have a fuel pressure issue. -
Mishimoto rad. Differances
IIRC, there are two different size lower hoses on 03-07 truck, I think F250 had a smaller outlet for the bottom hose vs F350-F550 -
6.7 starter in a 7.3
Watch the end of the video posted in the first post, at the end he explains how the nose cones have to be changed. I'll never buy another 7.3 starter again. -
6.7 starter in a 7.3
So it takes a nose cone swap to make a 6.7 starter work on a 7.3??? I was going to put a 6.4 on a 7.3, bought the starter and there was no way the 6.4 nose would bolt up to the 7.3. I've been using 6.4 starters in 6.0's and that's a nice upgrade, at the local parts store the 6.0 starter and... -
New Fuel injector Harness vs old
I know they have some different part numbers but they all interchange. -
IN NEED OF ZF6 TRANS
I'm looking for a 2006 6.0 6 sp manual 4x2 trans, Do you have one?- Gary
- Post #5
- Forum: Engine and Drivetrain
-
7.3 swap PCM question
A few things to be cautious of, 99 Truck were either split shot injectors on the late production and single shot on the early, tuning is different. IIRC Excursions had solid state glow plug module and SD's still had the solenoid so the harnesses will be different.- Gary
- Post #3
- Forum: Engine Conversion
-
Are delphi injectors any good?
If they aren't Motorcraft I do not use them. -
04 6.0 starts, runs for 10 seconds, then shuts off.
Sound like a loose injector, compression is leaking past the copper washer and aerating the fuel. -
-
03 dying problems before 4,000 mile round trip
If FICM voltage is good, egr clean the I'd look at the ICP sensor. -
Power Steering Leak
When the sector shaft seal leaks usually that means the shaft is rusty and tore up the seal. I haven't done any of the newer steering gears but on the older trucks I always replace the sector shaft along with the seals. If you want to try and replace the seal you don't use a press on this job... -
ALL 6.0 mechanics have a look
It's hard to tell in those pictures how big the metal pieces are, so I'm thinking roller needles from a failed lifter?? I don't think that metal caused the oil cooler to fail, it just ended up there. I'd look at the cam and roller lifters and oil pump, that metal came from somewhere. In my... -
need options on short block!
How are you doing the leakage test? What numbers are you getting? Try tapping the valve stems with a soft hammer while doing the test. Also have the piston on TDC.
Members online
No members online now.