Search results

Where else can you get it done in Davis? The county place in Kaysville is the only one I've known about. That is where I was fed this load of crap. Sent from my iPhone using Tapatalk

I don't know what to tell you.... They put it on a dyno, mash the throttle, see how much it smokes. I've never seen them do this for gas emissions but diesel emissions, yes. Davis County. Sent from my iPhone using Tapatalk

I live in northern Utah in a county that requires diesel emissions. The past few years, my 2001 7.3 has passed with flying colors. Due to the fact that the truck didn't come with a catalytic converter, all that is required for the emissions test is a dynamo-meter/smoke test. The result of...

Out of curiosity, can anyone tell me, after installing a new steering gearbox, what harm will be done by starting the truck prior to bleeding the steering system? When I installed the new gearbox last year I made this mistake and it has seemed okay since but is something that continuously...

Well unless I find a steal on the banks I'll be going with S&B

I have an SRP1.1 that works great I had an AIS 4 years ago. Not looking to go back to that.

Hoping that it will keep the air filter a little bit cleaner. I have an outerwears on my afe and can see signs that it's been wet in the past. Just wanting to protect the filter a little better.

I currently have an afe stage 2 but am wanting something that is somewhat enclosed with good air flow. I am thinking about an S&B or Banks. Do you all have any preference or experience with either of these? Currently leaning towards S&B because of the difference in price.

Okay. Mine won't. Does this sound like the pump could be bad? It doesn't make any kind of noise, just can't turn the wheel while stopped. It has to be moving.

I was able to get it bled and the steering feels so much better than before. No more slop!! Should I be able to turn the wheel with the truck at a dead stop? I think the P/S pump might be on its way out also.

That thought came to mind AFTER I wrote the post. Thank you, I'll go give it a shot.

Should I be bleeding it with the front end off the ground?

Installed the redhead today. Need to bleed the lines but the wheel will not turn. Any ideas?

Did you order them from a dealer? What was the cost? Any chance you'd have part numbers? Also, where did you get your new pitman arm?

Used my truck last week to haul a gooseneck trailer and tractor and remembered how bad my steering was. Finally bit the bullet and ordered a gearbox this week. It came today. Can't wait to get it installed.

I figured. Just making sure.

This doesn't apply if I'm just putting them on a 7.3, does it?

http://bit.ly/17mQCxC Here are a set of power heated mirrors from 1a auto. I need a set.

2011 6.7 1FT8W3BT1BEB88981 If anyone is able to run an oasis report on it, it would be much appreciated. Thanks

Thanks!! A great write-up.