im going to be installing my 2.5" carli backcountry kit next weekend. i was planning to run 37x13.5 toyo mts on the stock 20s and buying a spacer if i needed it bad enough. now i found a local guy who wants to buy my stock wheels so im thinking about buying 18s(dont need to). carli recommends 5-5.5" and dan told me i needed to be at 5.5 on the 2.5" kit but there are hardly any wheels out there with a 5.5 BS. my first choice would be method nvs or mesh but they come in 4.5 for 5.7BS. i really want to run toyo mts but they only make them in 13.5 wide which will make radius arm contact without the perfect offset, maybe contact even with the perfect offset. im ok with minor rub at full lock as long as it isnt damaging anything. but im not ok with it rubbing the body near the outside of the fenders. was hoping thered be a few guys here with advice as to the correct offset to have minimal rub. im ok with trimming or removing bumper brackets and some parts of the liner for the desired look of 37s. if nobody has any good ideas i may go with the 315/70/18 mt which is 35.7/13ish but those are a stiffer tire and dont look quite as good in my opinion. let me know what you guys are running