$400 motor goes 80k...

[FORD7.3]

Doesnt look half bad...

 

[CSIPSD]

Felpro headgaskets ok?

Trying to get all the parts and pieces here...

 

[Strokersace]

Felpro headgaskets ok?

Trying to get all the parts and pieces here...

I've used them on 3 different motors now with zero issues.

 

[CSIPSD]

I've used them on 3 different motors now with zero issues.

$25 bucks vrs $80... Hard to go the factory stuff...

Of course I dont want to do it twice.

 

[weekendwarriorfsw32]

Looking good Joe, how many times do you think you ran water on this motor?

 

[mandkole]

nice gents... good looking weather in bend!

 

[CSIPSD]

Looking good Joe, how many times do you think you ran water on this motor?

Ran a ton of water on this motor, stepped down the nozzle size for just cooling.

Have not run water in the last few months however, just dont need it when the temps are below 60*

 

[Stewart]

I dont need a new fancy turbo, the Modded H2e has worked well and taken everything I could throw at it. It just needs rebuilt, no contact to the housings, nothing other then the center section.

Sweet! I have the stocker with BDP's 1.0 exhaust I pulled off the Excursion you can use. Just swap me for that H2e!

Stewart :redspotdance:

 

[CSIPSD]

Sweet! I have the stocker with BDP's 1.0 exhaust I pulled off the Excursion you can use. Just swap me for that H2e!

Stewart :redspotdance:

I typed out a very funny response, but I dont want to get Garretts blood pressure up just yet this week...

Pulled the injectors out this weekend to send to Tim at PIS...

I was completely happy with the inside of this motor! Spotless. Been a long time since I have seen one this clean.

Passanger side VC has never been off. Has the WAY old style UVC harness with the plastic clips.

Drivers side has a remain in #2 and updated VC harness.

Didnt get a lot of time this weekend to mess with it. Full on part out will begin next weekend.

 

[CSIPSD]

So...

What color? I want something relitively easy to find oil leaks...

Thinking Cat Yellow...

 

[Black 02]

So...

What color? I want something relitively easy to find oil leaks...

Thinking Cat Yellow...

I'm doing Cat Yellow, so you cant...... :thumbsup:

 

[ParkerFly]

I was completely happy with the inside of this motor! Spotless. Been a long time since I have seen one this clean.

:whs: Doesn't even look like its been run!

 

[dentexpowerstroke]

I'm doing Cat Yellow, so you cant...... :thumbsup:

That's lame I was going to do cat yellow too.

 

[Jomax]

Let's all do CAT yellow. Nice re-build Csipsd. I envy your skills to pull a motor that fast. On a side note how are you liking those goodyear military tires?

 

[CSIPSD]

Let's all do CAT yellow. Nice re-build Csipsd. I envy your skills to pull a motor that fast. On a side note how are you liking those goodyear military tires?

Well it took Nick and I about 6 hours to get the motor out of the wrecked truck so!!! LOL

We yarded the motor, trans, and T-case all together just because it was a bitch to crawl under that wrecked truck on a trailer and try and do anything.

Motor will be Cat Yellow, picked up 5 can's of paint the other day. Hope to throw it back in next weekend, just been busy at work and with only 2 days a week at home...

I like the hummer tires, will be picking up another set when the time comes I do believe. True test will be the next time I have to haul the trailer (RV)... If they act up doing that its a deal breaker.

 

[Jomax]

Still with only a 4in lift?

 

[CSIPSD]

Of course...

 

[CSIPSD]

Motor question... I never replaced the LPOP on the last motor, not sure if I want to mess with it on this motor. If its not broken dont fix it kind of thinking?

Anyone have feedback? $80 bucks is not going to break the bank.

 

[DEEZUZ]

it will tell the tale of the condition of said motor... Just do it

 

[CSIPSD]

Ya, I guess...