Puller97
New member
So looking to build a 97 7.3 engine what rods and pistons should i use.
Hoping to be around 750-800
This.. maybe a bed plate. And a mechanical inline pump. Lol.. im over the heui crap for higher hp rigs.Slightly modified stock replacement Mahle pistons, billet rods of your choice, girdle, main studs, and half filled block.
This.. maybe a bed plate. And a mechanical inline pump. Lol.. im over the heui for higher hp rigs.
live life full throttle
If you knew how much i had into my dually then you would understand my thinking. Lmao!800hp is pretty easy to do and still be heui, especially if it’s a 6.0. LOL
Seriously, 800hp is harder to do on a heui 7.3, but the cost to go mechanical inline for that hp is a bit hard to justify.
If you knew how much i had into my dually then you would understand my thinking.!
live life full throttle
I was always a fan of the underdog heui 7.3 and i did well with it where i pulled but im sick od working on finicky electrical systems.I bet!!
To me, half the fun of making power with a 7.3 or 6.0 is the fact that they are heui, and not near the attention has been given to them over the years to make big(ger) power.
I was always a fan of the underdog heui 7.3 and i did well with it where i pulled but im sick od working on finicky electrical systems.
live life full throttle
I’m sick od working on finicky electrical systems.
live life full throttle
Lol. Yep! HahaWell now you don’t have to! It’s my turn now! Lol