Cowboyup
New member
Lethalthreat7.3 helped me a ton on diagnosing this system and figuring out what needed to be done. I will try to summarize what all I ran into and what was done. So the update from my last post is that compressor ended up being bad, put a finger over each hole on the back of the compressor and there was not suction or pressure, took this back to Napa and was warrantied out. Threw the new one on and vacuumed the system down still had a blockage in the system, and the only part not replaced was the evaporator. Bought a new evaporator and put it on. Then found the problem with the manifold set that Leathalthreat7.3 mentioned above. After finding this problem was able to put gas in it, if I remember correctly factory charge is 2.6 lbs, and I put in 2.3 lbs. Today it is 90 degrees out and this was my vent temp
[/URL]
