GROSSpolluter
New member
I did ede fuel bowl delete and I'm only getting 9psi out of the block. It should be 12 psi, so I need to check my airdog. So my question Is what port on the airdog do I thread a guage into?
airdog pressure
- Thread starter GROSSpolluter
- Start date
91turbogsx
Active member
It's on the top of the pump on the outlet side. Should be a single 1/8" NPT port up there.
buck russell
New member
what 91turbogsx said.
I wouldn't be surprised if your airdog is failing completely. Mine failed after we found a kinked line by the previous installer. Even after correcting it, the motor was toast. I will say that AirDog has a good warranty and they sent me a new motor right away.
I wouldn't be surprised if your airdog is failing completely. Mine failed after we found a kinked line by the previous installer. Even after correcting it, the motor was toast. I will say that AirDog has a good warranty and they sent me a new motor right away.
GROSSpolluter
New member
ive never really had a problem with it, i never checked it from the factory just installed it and went driving. my rail pressure never drops.
