slowcoupe
Member
I purchased a new truck a few weeks ago. Truck has AMP/Bestop Power Boards on it. However they are wired up to extend very oddly.
The passenger and driver side doors are wired to a plunger type switch. The rear doors however are not. Kinda an inconvenience. The passenger side switch also broke off(assuming someone kicked it stepping out) so the passenger step isn't functioning.
Any electrical gurus, or someone who has wired a bunch of these give me some insight on how to route the wires to the inside door wiring so that they extend with each door being opened?
The passenger and driver side doors are wired to a plunger type switch. The rear doors however are not. Kinda an inconvenience. The passenger side switch also broke off(assuming someone kicked it stepping out) so the passenger step isn't functioning.
Any electrical gurus, or someone who has wired a bunch of these give me some insight on how to route the wires to the inside door wiring so that they extend with each door being opened?