Another 60 swap question

[Yellow1000]

What exact parts are needed for this aside from the axle itself ? I finally have one , and it hasn't sold yet so I'm going to stick it in the truck. But I got to looking and reading a little here. What steering parts do I need? And what else am I forgetting? I know the calipers and all that will bolt right on.


Sent from my iPhone using Tapatalk and ****.

 

[Krause]

You need the steering from the F350 that's meant to go with the 60. F350 springs are preferred. Must have the track bar and track bar bracket, this will not be on your F250. May need taller blocks for the rear, expect 1.5 inches of lift from the Dana 60, that'll be personal preference. And of course the drivers side ubolt plate.
It all been covered, its out there.

 

[GallopingFord]

F350 front driveshaft

 

[Yellow1000]

I have the driveshaft also. Even though mines an auto I still need the whole shaft? Not just the U joint ?


Sent from my iPhone using Tapatalk and ****.

 

[idshred]

The double cardon joint is what's important about the f350 shaft.

 

[Yellow1000]

Oh ok. Thanks guys.


Sent from my iPhone using Tapatalk and ****.