I remember seeing tech articles years back on failed D ring seals on the discharge pipe off the HPOP into the cover. I installed a high volume pump 2 months ago and today I pulled the cover off to find that seal eroded in half. I looked in the cover and felt around, even installed a loose discharge pipe and it fits tight, seals great from what I could see...
I did however see a little chamfer of metal that was rather sharp in the galley that leads to the IPR. I shoved the discharge pipe in all the way(deeper than it goes when installed in truck) and the seal came back with a rip in it...
I have a used cover Im going to put in, but would like to know if anyone has had similar experience.
I did however see a little chamfer of metal that was rather sharp in the galley that leads to the IPR. I shoved the discharge pipe in all the way(deeper than it goes when installed in truck) and the seal came back with a rip in it...
I have a used cover Im going to put in, but would like to know if anyone has had similar experience.