Egr Prob with a SCT tuner

[childs25]

Guys I just put a SCT Livewire and exhaust on my 08 6.4L. When removing the EGT probe behind the DPF the nut broke and I can't remove it. Will it hurt to run the truck without that probe install until tomorrow? Thanks Brad.

 

[2good2Btru]

I would think it would be fine but not 100% sure. It would probably throw a code at best.

 

[kingranchstroker]

With that sensor unplugged the truck will fire up one time and run normal. then when you **** it off and try to fire it back up the next time it won't even crank , ECM will lock you out. I know from experience .

 

[childs25]

Ooopps!!!! Fired it up and it high idled but ran fine. Turned it off but haven't tried to crank it again. What will I have to do in order to get it back running if it want crank back up?

 

[lildevil02]

If jump the starter & replace the sensor, you'll be good to go.

 

[WoodBoy]

Your truck will start and run fine all it will do is idle high ~900rpms until you replace that sensor. You can unplug all of them if you want and it will still just idle at 900rpm

 

[childs25]

Awesome thanks a lot guys. This is my first DPF truck and I'm kinda new to it all. Thanks again for the help and advice.

 

[bigrpowr]

what these guys said brad.. sorry baby was fussy all afternoon and couldnt answer the phone.

 

[sootie]

normally speaking, you will have a high idle only. it wont do anything any harm.

form the dealer they only cost about 45.00.

glad it made the trip south ok LOL