Flowing injectors

[stroken]

Im in the beggining of re assembling my engine after melted pistons. Im not sure if it was from spraying it, or an injector hung. I will be adding 100% nozzles. where Is a good reputable place to send them to have them flowed to see if any are damaged or not?

 

[UPINSMOKE]

Mpd has a local place that flows all their injectors

 

[powerstrokin15]

swamps does it in house as well. RCD also can send them off to get flowed like mpd


Sent looking at my blown up 6.4

 

[zippyrat]

any test bench will tell you if you get the test sheet back

 

[bigrpowr]

100% ? Dayum.

 

[WoodBoy]

100% ? Dayum.

Exactly what I was thinking?

 

[Hammer Down]

where are you located?

 

[Jeff@Spartan]

100% ? Dayum.

Exactly what I was thinking?

Must have BIG air in the plans.

 

[stroken]

Located in Maryland. Im kinda confused with the questioning on the 100% nozzles?

 

[UPINSMOKE]

Theyre commenting Just because its a lot of fuel.

 

[stroken]

wasnt sure if it was a sarcastic, as I was doing something wrong. Iplan to run a single billet 75mm

 

[UPINSMOKE]

Look forward to seeing it run. Should go 11.0-11.2 or break into the 10's with a great 60'.

 

[stroken]

Thanks. hoping the built 5R will hold up.

 

[Jeff@Spartan]

wasnt sure if it was a sarcastic, as I was doing something wrong. Iplan to run a single billet 75mm

Should be a real stout setup.

 

[Smokin_Joe]

Good choice with the 100% nozzles. I do not see the point in little nozzels if you want big #s.

 

[spongebob915]

http://www.arundeldiesel.com/