Front drive shaft spinning

[Zmann]

6.4 has the same setup but uses a sealed bearing instead of a needle bearing

I don't know what to say it has to come apart for inspection look at the stub shaft like suggested and also the needle bearing

or pull the axle shaft out and stuff a rag in the end and call it a 2x4 LOL

 

[mustube]

To look at the stub shaft all you have to pull off is the unit bearing and you can see the stub shaft and the hub vacuum seal.

Sent from my XT1058 using Tapatalk

 

[mustube]

To look at the stub shaft all you have to pull off is the unit bearing and you can see the stub shaft and the hub vacuum seal.

Yeah a 6.4 will have a similar setup but will be way newer with fewer miles and all the seals will be in better condition.

Sent from my XT1058 using Tapatalk

Sent from my XT1058 using Tapatalk

 

[Pwrcummins]

Also won't be 15 feet in the air lol. Better fuel economy w00t! Lol


Sent from my iPhone using Tapatalk

 

[Pwrcummins]

Well I'm not allowed to sell it unfortunately. I hope my headstuds don't pop. I tried my best to tell them that these 6.0 are a ticking time bomb. Won't listen to me.


Sent from my iPhone using Tapatalk

 

[JMart]

6.0 are a ticking time bomb.

Sent from my iPhone using Tapatalk

So is a 6.4, just different problems and more cash to fix them.

 

[Pwrcummins]

I wanted a f150 but I only have 3 more years till this is paid off anyways. Once my 40" tires wear down I'm lowering the truck to a 4" or 6" on 35


Sent from my iPhone using Tapatalk