Reply to thread

Message: [QUOTE="QtrHorse, post: 70792, member: 1644"] Not that this pertains to this thread but the ultra fine statement is not needed. You could always go down in size if surface area of each strand is a concern. Instead of using 12ga, go to 10 and etc.. The only crowd that seems to be concerned with ultra fine strands and lots of them is the audio crowd because it translates into very flexible wire. I'm not a big fan of breakers because they take longer to trip than a fuse takes to burn/ break the circuit. Also, over time the circuit breaker will eventually have poor contact/ a higher restance than when it was new. This normally happens when they are exposed to the elements such as under the hood or under the vehicle. They are better used out of the elements. [/QUOTE]

Verification

Random media

2011-04-20_14-50-31_741

The Truck

0208151604

Magneto_rear_v2

2011-04-20_14-49-24_765

one_head

20103

Latest posts

Won’t start
- Latest: psduser1
- Yesterday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Jun 4, 2025
Suspension, Drive Train, and Tires

Members online

No members online now.

Total: 216 (members: 0, guests: 216)

Top