Has anyone installed to mount turbo without pulling motor

sideswipe7 · Apr 6, 2014

What can you guys tell me if it can be done.

bruce · Apr 6, 2014

I told you on the other site it can be done

Petro · Apr 6, 2014

Yes it can be done. Its not that hard.

sideswipe7 · Apr 6, 2014

But you didn't say how

bruce · Apr 6, 2014

Remove old turbo and up pipes. Bolt down a plate that goes were the stock pedestal would go (it has fittings for oil feed and drain. Slide in new up pipes with mount, bolt mount to plate mentioned before, mount has 4 studs, slide on turbo, hook up all the oil lines and boost tubes

TyCorr · Apr 6, 2014

Bingo! I'm not sure if someone asking this should even attempt the swap. Sound a little bit challenged from the get go.

sideswipe7 · Apr 6, 2014

i have never istalled turbo thats why i asked. i am
very good at tools and free thinking to find ways
on completing the prodject. I have worked on my
vehicles for a very long time i dont like to pay
some one to work on my vehicles if i had i would
have spend 10s of thousands of dollars.

Dieselboy. · Apr 6, 2014

sideswipe7 said:
i have never istalled turbo thats why i asked. i am
very good at tools and free thinking to find ways
on completing the prodject. I have worked on my
vehicles for a very long time i dont like to pay
some one to work on my vehicles if i had i would
have spend 10s of thousands of dollars.

They see me trolling. They hatin !:stupid:

If your so good, why the hell are you asking how to install a turbo and mount....