StrokiNDieseL
New member
Long story short I purchased H&S WG kit from a member & I'm trying to dial this thing in.. But dump pipe Is just staying open at all times :wtf: therefore I'm not building any boost???
1. Boost source plumbed to regulator
2. Regulator out source plumbed to WG
3. All extra ports on reg/WG closed off, turning regulator up & up has no change
4. Turbosmart 40mm WG ( h&s kit?) 2 top ports w/2 bottom ports.
I've heard these can be fun setting up, I'm sure something's just plumber wrong but I'm limited on support due to buying used so any help would be appreciated! :thumbsup:
1. Boost source plumbed to regulator
2. Regulator out source plumbed to WG
3. All extra ports on reg/WG closed off, turning regulator up & up has no change
4. Turbosmart 40mm WG ( h&s kit?) 2 top ports w/2 bottom ports.
I've heard these can be fun setting up, I'm sure something's just plumber wrong but I'm limited on support due to buying used so any help would be appreciated! :thumbsup: