Reply to thread

Message: [QUOTE="lsmith33, post: 56982, member: 1130"] :whs: i just did this myself last weekend. the valve covers are 13mm use a 10mm to break the glow plugs loose then use an 11 to get them out ( the 10 will get stuck sometimes against the rods.) if your doin orings as well only take the bottom hold down bolts out which are 8mm then u should be able to slide the hold down over the inside bolt an use a prybar to pop the inj out. jus be careful what u pry against. there are two oil plugs on each side that ya need to pull out to drain oil. they are 1/8 allens if i remember correctly. be very very careful not to strip those out. then reverse for the install. hope this helps ya [/QUOTE]

Verification

Random media

maple_grove_0681

2011-07-21_18-41-57_912

IMAG00113

Direct Drive upgraded solenoid

under the hood

iphone_pics_711

New Bumper

maple_grove_013

Do You Know Who I Am.....

20170502_213131_1494904244930

2011 F350 6" Pro Comp

Latest posts

Won’t start issues
- Latest: psduser1
- Sunday at 8:30 PM
7.3 Tech & FAQ
Windshield washer fluid reservoir
- Latest: psduser1
- Sunday at 8:27 PM
7.3 Tech & FAQ
F-250 & F-350 gear ratio question ?
- Latest: Mark Kovalsky
- Sunday at 6:57 PM
6.7 Tech & FAQ
Y
2001 Ford F350 7.3 l powerstroke diesel windshield washer fluid reservoir
- Latest: Yojih123
- Sunday at 12:15 PM
7.3 Tech & FAQ
s364.5
- Latest: htsummers22
- Saturday at 10:54 PM
Want to Buy

Members online

Total: 537 (members: 2, guests: 535)

Top