Reply to thread

Message: [QUOTE="wiseguy, post: 1349814, member: 12141"] I normally use ford gaskets always have. I have used mahle gaskets few times and vr few times done probably 30 sets of felpro. only seen one truck with over 150k on set of felpros its a f450 repo truck so far so good. I always use felpro lower gasket sets much cheaper in my opinion oil pan gaskets are better than oem. felpro front and rear main is identical to ford. Personally i think all of them are about the same its more about proper surface finish than gaskets. ALL 6.0/6.4 will struggle with proper sealing due to poor design. the best stud in the world is only going to add a small amount of clamp load. Proper surface finish good quality gasket and better fastener is as good as it gets. 99% of failed gaskets on studded trucks are either poor workmanship or being stressed beyond engine capabilities. Some people will just never understand you cant put 30,000 lb load on your f550 and run 190cc inj and big turbo ricky bobby tunes and expect it to go 100,000 trouble free miles. [/QUOTE]

Verification

Random media

O&G's 2011 F250 Journey

Punisher_s_1st_Photo_shoot_005

397929_211912255568144_100002481131528_446614_1177140714_n

Rudi

13_BMF_1

6A_800

edit2

New Bumper

front_axle_swap2

Latest posts

I must be getting old… Exhaust is too loud
- Latest: Derkperk
- Yesterday at 2:18 PM
6.0 Aftermarket
T
B&W hitch and shock removal
- Latest: TexMac
- Wednesday at 2:48 PM
2017+ 6.7 Aluminum Super Duty
6
ISSUES WITH CHOATES WARRANTY
- Latest: 6.7powersmoke
- Wednesday at 2:12 PM
1999-2015 Superduty Series General
Truck slipping into 4th
- Latest: Sterling6.7
- Apr 25, 2025
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Apr 23, 2025
Newly Enlisted

Members online

No members online now.

Total: 371 (members: 0, guests: 371)

Top