Redrock2000
New member
- Joined
- Feb 14, 2013
- Messages
- 89
- Reaction score
- 0
Being a disabled veteran on a fixed income this build will be done over time. With that said I've found the best price for pistons delipped and coated individually. I'm wondering if Mahles tolerances are close to the point where I can buy a couple of pistons at a time so I can have the block bored the
balance done with my forged rods and finally the final hone done when all 8 are purchased. I was going to wait till I refinanced my house but the truck has been sitting to flippin long. My goal is 600 hp 250/ 1 or 200 sticks, Adrenaline, and either a S369 or 467 turbo. The plan is to invest in the high $ stuff after refinancing. I'm 53 years old and this is no kids dream. Thanks for all information y'all can provide. Please don't say get a used motor I've been looking for 1 forever. When I have found one that isn't outrageous ( $3000 with 2 dead cylinders) or I don't have the cash in hand.
balance done with my forged rods and finally the final hone done when all 8 are purchased. I was going to wait till I refinanced my house but the truck has been sitting to flippin long. My goal is 600 hp 250/ 1 or 200 sticks, Adrenaline, and either a S369 or 467 turbo. The plan is to invest in the high $ stuff after refinancing. I'm 53 years old and this is no kids dream. Thanks for all information y'all can provide. Please don't say get a used motor I've been looking for 1 forever. When I have found one that isn't outrageous ( $3000 with 2 dead cylinders) or I don't have the cash in hand.