Manifolds

[Groomzybanshee]

Who has ran the new Bd's? Can't decide what to put on my 2.5 build.

 

[Dzchey21]

no one that i know of but i would def run them, the price is right, they are cast so they should hold up well. Everything about them screams win

 

[Groomzybanshee]

no one that i know of but i would def run them, the price is right, they are cast so they should hold up well. Everything about them screams win

That's what I was thinking just don't want to put them on an lose power.

 

[Dzchey21]

i doubt you will, many people have ran 6.0 ported manifolds ect with good luck, the only issue was with the steed speads and i think it was because the outlet was too big

 

[co04cobra]

RCDs are very nice pieces too. I am trying to decide between them and the BDs.


I really wish someone would do some dyno #s or CFM comparisons on some of the aftermarket manifolds available now.

 

[ncollins64]

I'll be supporting Jared and going with the RCD 6.0 manis. Very nice looking pieces as are the bd pieces.

 

[Powerstroke Cowboy]

I will admit they are a nice looking piece. Not only are they nice cast piece BUT the thicker wall then piping will help hold the heat in better and should help drive the turbine harder. Not to Mention BD also took the cast manifold and ported the runners to improve velocity and evacuate the cylinders. They took the casting and improved it by porting it to get what they wanted. That tells me they wanted to get the most out of it they could.

The only thing I am not sure about is where they placed the whole for the EGT probe. And it might not be a big deal.

And like Dustin said the price is right. Well more then right to me. I would not be scared of them.

 

[TD-5]

The ports for both the EGT probe & the BP sensor are in the LH manifold. BP is at the fwd top, EGT is on the side at the back

 

[MINK]

Whats pricing on the bd manifolds? I need to check them out

 

[TD-5]

$470 -$500 depending on where you deal

 

[smokinstroker]

Pretty clean for a cast piece, and the price is right for anyone that is looking to ditch the 6.4 mani. But the RCD and old MPD pipes are really slick.

We sell the BD for 470 a set, makes the price hard to beat for the average customer.

 

[Powerstroke Cowboy]

We run right @ 495.00 shipped to the lower 48 states. ^^^^But I can see I was beat!

 

[capt dong]

whats the sensor on the right hand side of the 64 manifold? egt?

 

[Pizza pig]

We should be releasing our manifolds again soon as well


Hellen Keller sent this?

 

[08BIGRIG]

I would bet that these work very well. BD has been doing lots of very impressive testing on their products lately with great results.

 

[Extended Power]

Post a picture of inside the ports...shows how they are formed to help the flow of the exhaust.

 

[Fordtrucks]

I went with stainless 6.0 style log manifolds and pipes from RCD.love em!

 

[JrStroker]

What's the difference in these and 6.0 manifolds?

Sent from my DROID RAZR using Tapatalk

 

[Fordtrucks]

These are a stainless header lookin deal instead of the cast iron factory 6.0 deals.

 

[JrStroker]

So is there a floe difference? Better heat containment?

Sent from my DROID RAZR using Tapatalk