Grey_Matter
New member
everything i searched pointed to the blend door actuator...it still doing the exact same thing.
ok so i warm my truck up, its blowing warm air, within 30 seconds of driving it will be blowing cold air.
both thermostats have been replaced, blend door actuator has been replaced, heater core is not clogged.
after driving for about 10 minutes at operating temp i can open my gas bottle and put my finger in it, and the cooland isluke warm at best.
what do i need to do to get heat in my truck?
2008 F250 6.4L
EDIT:
on another note, i cycled through cold and hot with the key on and cannot hear the blend door opening or closing, i can hear the other two (recirculate and Defrost/Floor/Vent) working just not the one for the temperature. is it possible i am not getting power to it? is there a fuse or is the fuse for the entire control panel?
ok so i warm my truck up, its blowing warm air, within 30 seconds of driving it will be blowing cold air.
both thermostats have been replaced, blend door actuator has been replaced, heater core is not clogged.
after driving for about 10 minutes at operating temp i can open my gas bottle and put my finger in it, and the cooland isluke warm at best.
what do i need to do to get heat in my truck?
2008 F250 6.4L
EDIT:
on another note, i cycled through cold and hot with the key on and cannot hear the blend door opening or closing, i can hear the other two (recirculate and Defrost/Floor/Vent) working just not the one for the temperature. is it possible i am not getting power to it? is there a fuse or is the fuse for the entire control panel?
Last edited: