RPM questions/advice

[powerstroked08]

Hey guys, Im not sure what rpms are safe to run on a mostly stock truck like mine. Mods are in signature. Just looking for some input or advice on what to do. Raise the limiter for pulling or leave it alone. But I think there is more to be had. So what do you think?

 

[BFT]

Leave it

 

[Vinny07psd]

Leave it!

 

[powerstroked08]

I wasn't planning on trying to turn no 6,000 rpms. I was just curious if bumping it up to 4 grand was ok I guess. I only turn 3,600-3,700 now. But if not thats all I want to know, I see some guys have higher rev cams but the budget wont allow that haha! Plus I don't want to have to get the rotating assembly balanced.

 

[Stroked777]

I turn my around 4000-4300 before. But I got a cam, wouldn't suggest higher than 3700 with stick springs and push rods

 

[BFT]

What's the point of raising the rev limiter if power starts to drop at 32-3400 when stock?

 

[Will@Rudy'sDiesel]

:whs: You go much higher then that your gonna to end up hurting the engine, majorly.

 

[weekendwarriorfsw32]

Just because you can doesn't mean you should. I would leave it.

 

[powerstroked08]

I was only looking for a little bump in wheel speed when pulling without going to a different gear. But that's why I figured I'd ask you guys so I'm going to leave it alone. Thanks a lot guys I appreciate it!