Yea that would make it even better.A couple of holes for mounting or a port for a pressure gauge would have been cool.
That is a good link for the guys that do not want to have to fab those lines. A couple of holes for mounting or a port for a pressure gauge would have been cool.
I wonder if you could drill and tap that for 1/8" NPT to put in a gauge without any problems.Yea that would make it even better.
I figured you do.Sorry I get asked the question all the time and I just do not have the answer. I can tell I used an adjustable hobbs switch is all. I just adjusted it to get the pressure I wanted.
It is hard telling. There are so many conversion threads on the net it isn't funny.I kinda like that block idea. didnt someone use some fittings from parker to do pretty much the same thing?
I will look around.It was TimC63 that did it with the parker fittings
If you look around the web there is a conversion chart to match wrench size to fitting size. If you cannot get to them on your rig I will check on mine.