Reply to thread

Message: [QUOTE="OOWeaver68, post: 1510, member: 82"] courtesy of slickwilly. Here are some instructions for the fuel filters. Pretty easy to DIY 1) Place bucket or pan or some liquid holding device under the frame rail fuel filter (inside of frame, under driver seat). 2) Open the water drain valve (plastic lever on the side of the filter housing that you're supposed to drain occasionally). 3) Let diesel drain into bucket. 4) Drink a beer. 5) Remove filter cap on top of motor while diesel is draining under truck. 6) Replace filter on top of motor, re-install cap. 7) Drink another beer. 8) When all diesel is done draining from plug, close drain valve. 9) Remove filter cap from frame rail, expect some dripping of fuel, and a wet filter. 10) Replace filter, re-install cap. 11) Drink another beer. 12) *Very important* Turn key to on position without cranking truck, leave for 20 seconds, turn key off for 20 seconds, do this cycle at least 5 times to purge air from the lines. 13) Crank truck, let idle for a minute, done deal. [/QUOTE]

Verification

Random media

eleanor_at_dereks_3_1

3E43Ga3F85G75Ff5Jed254d2e574e6b221a7f

IMAG0349

IMAG0523

0131

IMG_20170708_172332689_HDR

photo-4

Hydroboost and power steering

95_Bronco_conversion_pics_015

Latest posts

T
B&W hitch and shock removal
- Latest: TexMac
- Yesterday at 2:48 PM
2017+ 6.7 Aluminum Super Duty
6
ISSUES WITH CHOATES WARRANTY
- Latest: 6.7powersmoke
- Yesterday at 2:12 PM
1999-2015 Superduty Series General
Truck slipping into 4th
- Latest: Sterling6.7
- Friday at 7:18 PM
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Apr 23, 2025
Newly Enlisted
A few turbo questions and a rant
- Latest: ghohouston
- Apr 23, 2025
7.3 Aftermarket

Members online

fastersteve

Total: 749 (members: 2, guests: 747)

Top