Ts chip repair

[Steve's red stroker]

One of the prongs that slide over the PCM ended up getting a little misconfigured, is there a way to repair that end, or someone that can fix it? O

r do I just order a new one?


Sent from my iPhone using Tapatalk

 

[Tom S]

I might try and hunt down a fried chip and doing a replacement if you are very good at soldering.

 

[Steve's red stroker]

I might try and hunt down a fried chip and doing a replacement if you are very good at soldering.

That's what I was thinking, bad thing is I had one sitting for about the last 4 years in my toolbox and about 3 months ago i threw it out


Sent from my iPhone using Tapatalk

 

[njjeep]

I got a bad one I was going to send back to TS to see if they can fix it. It's not physically broken just the fuel pump wouldn't turn on sometimes with it.


Sent from my iPhone using Tapatalk

 

[Steve's red stroker]

I got a bad one I was going to send back to TS to see if they can fix it. It's not physically broken just the fuel pump wouldn't turn on sometimes with it.


Sent from my iPhone using Tapatalk

I have a burner so I could tell you if it's good yet, just kickin myself now for throwing that bad one away


Sent from my iPhone using Tapatalk

 

[SPEEDDEMON31176]

Take a small pick and gently pull the tab back over where it belongs.

 

[Steve's red stroker]

Take a small pick and gently pull the tab back over where it belongs.

I ended up changing the whole j3 connector, the tab was broke towards the bottom, wasn't the funnest thing to do, but I have working again


Sent from my iPhone using Tapatalk