Installed a Rigid E series 20" light bar last night. Now it is time to wire it up. I plan to use Upfitter #1 (yellow wire under dash) and the brown pass-thru wire in the engine bay. The question I have is with the Rigid harness.
Here is a pict of the relay:
Other than using the plug that connects to the light bar, I *believe* the blue wire gets tied to the upfitter (pass-thru) wire and the ground of the same bundle (that would go to the switch) goes to ground. The rest of the wires would not be used.
Is this correct?
Here is a pict of the relay:
Other than using the plug that connects to the light bar, I *believe* the blue wire gets tied to the upfitter (pass-thru) wire and the ground of the same bundle (that would go to the switch) goes to ground. The rest of the wires would not be used.
Is this correct?