Search results

https://ibb.co/mCgabn Can someone tell me what support/bracket goes here? 05 f350

Truck ran fine night before went to start it the next morning and I noticed I don't hear the injectors buzz when I flip on the key, finally got it started and it ran rough for about 2 minutes then all was fine. Through a code for icp pressure too high went to start it today and it's doin the...

07 ford superduty Transmission with transfer case- $1250 FICM-$220 Front axle-$500 Dash-$85 Injectors- $100 each Front driveshaft-$100 Receiver hitch-$85 Instrument cluster-$150 PCM-$60 Fan-$85 Starter-$50 Grille-$45 South San Antonio Tx 210912sixthree77

How much of the stuff do I need to order to do a headgasket job I don't have the stuff that came with the studs

On my lifted 05 I've had death wobble twice in the past month both times on a right handed curve on the interstate. Took it to the alignment shop and they say everything checks out other then my 40" toyos are down to about 30% tread. I did find some play in the passenger side sway bar end link...

$1000 pre ban tuner ready to go

Anyone know where I can find the female end of the rear taillight harness? 05 f350

Just bought a 2011 f250 can't get the dome lights to come on when I open any of the doors or by turning the knob on the dash but I can turn them each on manually any ideas?

05 6.0 blows blinker/brake light fuse almost instant I've checked the trailer harness any ideas? Fuse #18

My fan clutch harness got caught in the fan last night and the truck shut off and said PCM fault, towed it home just put a new fan clutch in and when I try to start the truck it says check gauges and I get nothing. The glow plugs are not cycling under the hood like they should be either.

Anywhere I can find one locally my radiator needs to be fixed and truck is down till I get it fixed. San Antonio tx

Who makes em I have the vvme 55w 6k hids on my 05 with no problems for 6 months then one of the ballast went out and I've gone through 7 or 8 replacement ballast in the past 2 months they are junk. Sick of poppin the hood and swapping in ballasts all the time.

Changed the front hub with new o ring on my 05 and now it's sucking air what'd i do wrong

Long story short the centering pin from my block sheared off flush in the spring perch on the axle, what'd be the quickest way to get it out?

Where can I buy 4 new leafs for a 99 f350 4wd? Factory replacements?

Can these be removed from the door panel?http://50.6.73.68/picit/1398366529.3125.iPicit.jpg

Anyone know where I can find a drop bracket for a 95 obs with 8" of lift? 4wd f350 gonna be lifting my brothers truck piecing together the lift.

Who alls done one any tips/tricks? I've done plenty of 4wd 05 and up but gonna be doin one on my buddy's 2wd 2000 f250 next week.

Have an 05 with 12.5" lift looking to get a set of 10" deaver springs for the rear so it will sit level with the front, my question is won't I have to run some type of block to correct pinion angle? Or am I overthinking this one.

Who has a dual shock mount for the 05-07 for the front?