Recent content by DP-Tuner

I agree the billets are holding at that power. I keep seeing a trend of Swamps tuning with blown motors. I am not sure if it is the tuning or something else. I know that many other factors come into play but most like to blame the tuning. Jody

I agree. Been there and done that after a turbo let go on the dyno. I am still reminded of that every time I talk to the Dodge owner. Jody

I see a trend here. Sorry for your misfortune. Time to look at what really caused the failure. I have a PMR motor on the stand available. Jody

6.7 tuning Jody

Formula... This is just simple math like 100/5= 20. This is what I used for the 0-100 psi fuel pressure sensor. Nothing is limited since you can enter your own formula. Any sensor that supports 0-5V can be used once you figure out the correct formula and enter it. Jody

Mine with the 195 ran 220 coolant and now with the 180 it runs 199-203.

Unlike most rotary knob style switchers our EX and Gauge style switcher is equipped with a microprocessor. A rotary knob style switch is designed for a pin to be grounded in order for the chip to determine what position to be in. The EX and Gauge style switcher from Moates.net design is an...

The guy I use thinks the stock tolerances are way too much and he believes in making everything much tighter. Look for computerized balance equipment, CNC machines, etc. The computerized equipment will allow much more precise tolerances. I only trust him to verify the bores etc.

The oil temps are related to coolant temp. Look at the oil cooler and you will see that the coolant is what determines the oil temp.

Outside is what I did.

Ok and Jeoy is the one selling the 180 degree thermostat and he is the one I got mine from. He will tell you that the lower coolant/oil temps are key. My Excursion idled like crap with the 203 degree thermostat and when I switched it over it idled perfectly.

I prefer to see 180-201 and that is what I see in my Excursion with the 180 degree thermostat.

Maybe if they really know how to put together a good motor. I have seen way too many cheap builds that are way worse than stock. Go to the machine shop and have them show you the equipment they use to measure, balance, & verify the parts. Also make sure they are VERY clean and organized in...

The EOT should be correct. The oil temp is key because of the HEUI injectors.

I have a number of customers running them. I have not live tuned on one but they seem to love the setup. Jody