Recent content by levi1906

so your saying bad tuning could be a problem here

I purchased a custom tuned chip for my 7.3 about a year ago through beans diesel. I also at the same time was getting injectors from performance injection systems. I had ordered 175/30 injectors and so I ordered my chip tuned for that size. after the fact I was contacted by p.i.s and found out...

E99 7.3, P.I.S 160/30, beans 6 position chip, WWII, 4" turbo back I replaced injectors back last july, and since then my truck hasn't seemed to run quite right. it didn't seem to have the same feel at take off. like it was lacking power, and would idle very much different than I was used to...

so do I need to be looking for up pipes for obs then?

what is the difference in the e99 7.3 that these up pipes wont work on pre 12/6/98? http://parts.autonationfordwhitebearlake.com/partlocator/index.cfm?action=AccessoryCatalog&catalogid=7351&siteid=214771&categoryID=158096&subcat1=158121

ok excuse me for being an idiot I found what I was looking for. P0269 Cylinder 3 contribution/balance fault P1140 Water in fuel condition P1249 Waste gate steady state failure P1298 IDM failure what should my next step be? I already took care of the water in the fuel so im sure that code...

I just got my aeroforce scan gauge put on my truck. (way awesome product! if you don't have one, GET ONE!) buzz test gave me p1298 cyl contribution test gave me p0269 and I also had p1249 and p1140 can anyone of the great minds on here translate these for me? or is there some where I can...

Welcome from canton nc!

Actually I pulled the bed off. I didn't get a chance to put a pressure gauge on it yet. Hoping to get that done tomorrow after work. Will getting a buzz test done tell me for sure if it is the injectors?

I just pulled the sending unit back out, cleaned the socks in the mixing chamber. very dirty! made me kinda hope full that this would fix things. however it did not. im going to get the parts to rig up a fuel pressure gauge just to see what im getting. should be close to 60psi???? I tried...

No I cleaned everything out of the fuel bowl

I did run diesel kleen through it. With no affect. Also the pickup screen was cleaned while I was cleaning the tank

Filled up with fuel the other day and the truck started running rough. Changed the fuel filter, ran good for a few miles, then started running rough agian with no power. I then drained the fuel tank(fuel looked terrible), and changed the filter again. Once again it ran fine for a little while...

some have said it was the dual mass and some have said its the solid flywheel. can anyone on here tell me for sure?