I feel fortunate. Regularly -20 F around here. Never gels & I've disconnected my fuel bowl heater. We must be getting good Winter blend fuel. She does burn cleaner in the Winter.
I vaguely remember seeing them on the Power Block on Spike TV. Thx for jogging the memory cells. I'll look on their website. Im still feeling lazy ;)
Sent from my SPH-L710 using Tapatalk
Thx. I checked with Ford. Too old for those parts. I was just feeling a bit lazy. I'll get under her tomorrow & bend some lines :)
Sent from my SPH-L710 using Tapatalk
Anybody sell pre-bent / factory fit rear brake lines for '95 F250 7.3 with HD rear axle ? Driver's side 1/4" * 1/4" about 18" long. Passenger side 3/16" (at axle fitting) * 1/4" (wheel cylinder) about 48" long ?
Sent from my SPH-L710 using Tapatalk
Keep in mind that my first engine rebuild was a 216 Chevy six followed by the far more advanced 235. Have any of you seen the 'spoons' on the connecting rods for splash oiling ? Cruise control in my first pick-up was a factory hand throttle on the dash - pull out & twist to lock. I'm older than...
Sometimes a coolant flush will flush out the corrosion in a heater core or radiator that was selling up a small pin hole. I'm finding out the diesels are very complex & not at all like the gas engines I've played with for 50 years. The old tricks of black pepper, egg whites or Bars stop leak is...
If you're looking for a broken wire, you'll get no reading on the ohm meter if its a clean break. An intermittent short is tougher to find. I'm guessing you'll have very little to no resistance on good wires.
Someone will surely correct me if I've gotten this wrong. Tracking down electrical...