Search results

Was going thru my heads this evening, putting in some beehive springs, and lapping the valves. all of my exhaust valves have bad pitting in them. So my question is are there any vendors on here that sell valves. Just looking to go back with stock valves.

Just helped a buddy put a motor in his truck. He did the Windows mod on his old motor got this motor from a wrecked truck. Everything on the motor checks out fine compression wise. It starts right up no problem and idles smooth for a few seconds then the idle starts to oscillate up and down till...

This a long story but I had my motor built about 2 years ago and on first startup the truck would run but was not showing much lpo. Turned out it was a missing check valve or ball in the oil cooler. Put a cooler on that worked and all was well. The truck had a bad shake to it from day one. Then...

I have had this vibration almost since I had my motor built in Feb. But the truck has not been running much. first saving money for another hpop then recently a new fuel system since the air dog couldn't keep up. I have been trying to address one thing at a time. So tonight I was drilling out...

Truck is a early 99. Fully built motor w/ (s468, P.I.S 300/400, HB Jr. Hpop). This is a new build with only about 3k on it. Under any sort of load at all, in all tunes it starts to miss and fall on its face. If I let out of it and get back in it most of the time it will smooth out and take off...

Truck is a late 99 F-350 CCLB DRW. Back in the spring. We were pulling a trailer to the Hatfield McCoy trails. the transmission got really hot going over the mountains. Not sure on temp (no gauges) but when we got there and stopped it boiled fluid out on the ground. It never slipped any until it...

I have a set of 16x10 Polished pacers I'm trying to sell. They came off my 99 F-250. A friend I work with Is interested in them. He has an 08 F-250. Will a 16 fit on the newer trucks?

I orders a BTS valve body for my dads truck. It's a 99 F 350 cclb drw. He went to put the new valve body on and not paying attention took off a smaller valve body toward the rear of the tranny. When he took it off 4 steel balls fell out and I have no clue where they go back. When he showed it to...