Search results

Looking for a set of factory 2" F250 4x4 rear blocks if anyone has a set they don't want an arm and a leg for. If you have a set you're willing to part with shoot me a PM. Thanks

Any Ford factory techs or programmers that know how this regen system is supposed to work? Mine usually works normally, or at least what I consider normally. It works it’s way up to 100%, goes into regen, heats up the DPF, works its way down to about 23% and shuts off the process. Continues...

I recently sold my old 7.3 and bought a 14 6.7L. After driving it for a bit I realized it drove me nuts not being able to monitor my EGT's and the regen cycle so I bought an Edge CTS insight so I could keep track of the EGT's, regen status, and other stuff. My question is, for those of you that...

Sold my old stroke so I don't need this chip anymore, Gearhead tuning for stage 1's up to 175/30 injectors. I was running it on a 96 with 175/30's with an intercooler, electric fuel, 17* hpop but you don't need all of that to run it. Chip positions, Stock/heavy tow, high idle, drive thru...

I have a 96 CCLB that the rear end hops or bucks about 95% of the time when operating in the 39 – 42 mph area when the truck is unloaded or lightly loaded, problem is I seem to spend an enormous amount of time in that speed range with the speed limits in our town. Doesn't matter if I'm...

This is the new wheel Bob came out with a couple months ago, I'm trying out a new wheel now so I don't need this one anymore. $200 shipped, it's in the box ready to go, comes with O-rings.

I was tired of the factory donuts leaking after ~10 thousand miles every time I replaced them and I just couldn't get my head wrapped around paying IH $800+ for a set so I asked Jake if he would be willing to add bellows to a set of factory pipes. He said he had actually done a few sets and...

Went to Efuel this last weekend so its no longer needed. Recently (2 months) freshened up fuel bowl from my 96, also has a 2 month old filter, new hoses to and from the fuel pump and return line, new parker square orings for the lines into the heads, new banjo bolt gaskets, and the good fuel...

Does anyone make aftermarket 4340 rear axle shafts? I have a buddy that broke one and it ate the housing and shattered the detroit. If not, it's gonna get old replacing housings and regearing every few months.

For 96-03 7.3 in good shape. Post up or PM me. Pictures of the oil pump surface would be great. Thanks

Can anyone tell me if a SD timing cover can be used to replace an OBS timing cover? It's for a 96. Mine has a antifreeze porosity leak on my OBS and I'm having a difficult time locating an OBS cover. Accessory bracket mounting and oil pump pickup are my two biggest concerns. This is a DD so I...

Probably a stupid question, but on a crew cab rear seat, what are the two pins on the lower seat toward the center for? My OBS seat had them and the SD seat I just swapped in has them also. Thanks

Just the nozzles, no injectors included. I bought them new from Rosewood, they are a year old and have approximately 11k on them. I took them out and put 30's in. If anyone is planning on rebuilding their injectors or having them rebuilt and they have over 150K on them you can buy these for a...

How about a mark all forums read button, that way I know where I'm at when I start each time?