6.4 crank no start. Mpd s472 amd code p0232

[ramonpowerstroker]

sounds like a bad combo... ill be at the ford house if you need me

 

[SEABEE08FX4]

do you think the oil cap makes a difference???? im running rcd oil cap.. with oem oil filter.....

I doubt it being no one else has had an issue with theirs.

 

[ramonpowerstroker]

Changed regulator... still have problems. Change oil filter to see if it is it

 

[ramonpowerstroker]

Nope still have problem..... now it won't even start. Just turns over with oil light on

 

[ramonpowerstroker]

Running 5w-40 rotella. Mechanical gauge on the oil cap....

 

[ramonpowerstroker]

Come on boys... stuck in a shop with 2hrs and 30minutes left..

 

[ramonpowerstroker]

ok turning over I see 40 psi... hasent been started since last night

 

[ramonpowerstroker]

40-50 psi. when it starts for 2 seconds I see 70 psi

 

[SEABEE08FX4]

At this point I would just go back and double check all the tings you did.

 

[ramonpowerstroker]

I just did...

 

[forcefed6.4ford]

You might have to open it back up.

 

[ramonpowerstroker]

new oil cooler, new oil pump... new eop sensor, new oem oil cap from ford... still don't work. my oil light turns on everytime I turn the truck over....

 

[ramonpowerstroker]

is there any oil level sensor/ what do you mean open back up? I opened the valve covers and checked everything. what the hell can it be???? i

 

[forcefed6.4ford]

I dont believe there is and oil level sensor. That would not explain your oil pressure issue. Maybe you have a pinched oil line somewhere, or perhaps your oem parts are faulty. Either way, crack open the wrenches and get to work.

 

[forcefed6.4ford]

I just had a thought... Ford changed their filters a little while back and now there is a small white plastic insert that gets installed on the top of the spring assembly of the filter housing. If that little plastic bit is not in there, perhaps that is causing you high oil pressure.

 

[ramonpowerstroker]

Yup that's what I'm thinking working on that

 

[ramonpowerstroker]

Nope not it

 

[ramonpowerstroker]

Ugh where to start? Oil pressure when turning over is 35 psi... try k turns on... then dies.... wrench light and oil light.... codes about intake sensors, injector cranking low(because long cranks) and vgt actuator... and a U-something code...

 

[ramonpowerstroker]

I don't know where to begin? Its all under the intake manifold, turbo and other stuff... I need a lot feedback about this truck because I'm lost of why its giving me this problem if I checked all my new OEM parts from ford

 

[SEABEE08FX4]

Have you made sure you have everything plugged back in, hooked up correctly and installed correctly?