Strokersace
Well-known member
So I put all new front brakes on a 2wd dually recently. New rotors, new pads, new calipers, slide pins, etc. I also had the vac pump lines undone from the vacuum booster as well. Got the brakes bled, all new fluid in, and the vac lines hooked back up, however, the ABS light is always on in the truck now.
It's an auto and the speedo is working fine so I know it's not the VSS in the rear axle. The cruise works fine, so I know it's not the "recall" sensor on the end of the master cylinder. No codes on the scangauge cause ABS codes don't show up on them.
Like I said, fluid is new and full. All front brake components are new.
ANY IDEAS???
It's an auto and the speedo is working fine so I know it's not the VSS in the rear axle. The cruise works fine, so I know it's not the "recall" sensor on the end of the master cylinder. No codes on the scangauge cause ABS codes don't show up on them.
Like I said, fluid is new and full. All front brake components are new.
ANY IDEAS???