Recent content by no_pistons7

well the wts light comes on and its all good, last two times i go to start it (cold start) itll idle for about a min fine (no rough shakey cold idle) then the rpm will hiccup then the truck turns off and i notice the rpm needle is reading around 300 for about 5 seconds or so then drops to...

went to start the truck last night and had no "wait to start" light and it just cranked and cranked and wouldn't fire...this morning i unplugged the fuel bowl heater connector and the WTS light came on and it fired right up, from what i understand the PCM fuse SHOULD have blown if that was the...

just went outside to start it, cranks but a bit slow heard a slight clicking under the dash i guess its not turning over quick enough to start, hooked charger up to it and it started...batterys reading 12.2 which seems fine...gunna pull them out and go get new ones under warranty.

k so Icp sensor was bad that was changed, ran fine for a day and then wouldnt start at all again just crank.....i changed the fuel filter about a week prior to all this (i rarley drive the truck so it had almost no miles on the new filter) so i go to take the fuel filter off to check make sure...

so last night heading to a buddys truck just shuts off no warning nothing was running fine, cant get it started it just cranks, waited for my buddy to show up and it fires right up no problem after sitting a bit then dies after a few mins...we checked voltage on batterys they were all over the...

just spent alot of time getting it lined up best i could, not that difficult

its been a while

awesome thats all i need to know..will be going with him, prices are great on the stuff i wanted too. thanks guys

oops wrong section someone can move to suspension, my bad

anyone running anything PMF or have any first hand experience with them as far as quality etc? looking into there crossover steering kit and there crossover track bar kit for my 01 7.3

:naughty:

24x14 on 37s....once these tires are dead going with 40'' m16s

been a while sence i posted a pic of my donk

anymore pics of the lifted dually. looks gooood

that red reg cab is amazing i wonder how a black mitre cut 7'' single stack about cab height or a bit lower would look :drool: