Search results

Has anyone dealt with this before? A/c is only lowing hot through defrost. I can hear the compressor cycling. Just know starting to diagnose but can’t find anything 6.0 related online.

I have heard that updating the TS will remove the egr off function and not allow custom tune uploading anymore. Is this true? I have a TS I have not updated in about a year. Also been running the canned tunes but am ready and wanting custom tunes. What’s the true story?

CEL and SCT reads P0472. Has that off, deep, gas engine sound like its struggling. Not boosting like it was prior to code. Could a suspected cracked up pipe cause it. I’m pretty sure I hear it and and feel it. Already have a replacement-just looking for a weekend to do it. Thanks all.

I’ve been through three in the past three months. Where should there be a rubber seal?

Yes. Motor craft.

Why do I keep going through these things? 3 in 3months and ordering a 4th. My drive to work and back is about 15min each way, top speed is maybe 70mph. Truck is an 07 with 210k. I have a powermax turbo, CAI, and 4” straight exhaust. I’ve changed the MAP and barometric sensors. Ebp harness is...

I got the. Viper installed. It works great. I wanted the voice module as well but they went through five or six and said they couldn't get any of them to work right. Installer said they got Viper on the phone to troubleshoot but no success. Viper said all of them must be defective. I hope they...

If you have an amplified aftermarket sub and have upgraded 6x8's, the 6x8's need to be amplified as well to balance it all out. One 5 channel amp will work wonders on a simple setup like this.

Correction-"are just NOT period correct....."

I just ordered 4 new factory fog lights to do the "quad fog" mod on my '07. In my opinion, LEDs are just period correct for these '99 to '07 trucks.

What year model do those fit? Will they work in my '07?

Getting nervous about truck getting stolen. '07 Outlaw. It's already been broke into once, but now I've got enough done inside and out where I don't want to face losing it. Can someone reccomend a good set up? Does anyone still make those alarms that talk when you get too close? Do they have...

Look on Ebay. Search for the mirrors and you should find the harness.

On my '07 I ******d the cooler, but left the EGR valve in and plugged in. It still throws the CEL on periodically. I just undo the batteries and it turns off for quite a while. Just ordered a tuner as well to keep it off.

I ordered this through Ebay. Most of the suspension parts were MOOG. Also replaced trac bar ball joint. 07 Outlaw 250 with 195,000 and lifted on 35's drives nice and tight like a brand new half ton. No play in steering or anything.

I Have an 07 f250 with 4.5" lift, 35x12.50x20's. My front end was all over the place. Left front tire felt like it was gonna go at any time. I replaced upper and lower ball joints, tie rod ends, and trac bar ball joint. Truck is nice and tight like a brand new one. No wobble, steering is tight...

So they are only on the front of the engine? The only video I could find was of a 7.3 and it showed them on the backside. Thanks again!

Does anyone have a write up or can guide me on doing the banjo bolt upgrade on an '07 6.0? I'm fixing to do an oil/filter change and was going to do the blue spring and banjo bolts as well. Also, when doing the lower fuel filter I was going to take the side cover of the pump where the water...

I've got an 07 turbo with a new stainless unison ring all cleaned and ready to go. $400 shipped. PM me if interested.

I put a RC 4.5" on my truck back in December. '07 F250 with 180k and factory shocks still on it. I got one of the newer kits with the 2.0 shocks and a dual steering stabilizer with the 2.2 shocks. Rides awesome. Kit went on with no problems either. I would highly recommend a RC lift to anyone.