Who has cracked a 6.7 block and at what HP and application ?
Thanks !
I know of a 2.6 puller, 1,000 hp range
Who has cracked a 6.7 block and at what HP and application ?
Thanks !
For some reason vp/12v rods are not holding up in 6.7 engines. I have bent 3 sets in them now and some of them at hp levels less then what a stock cr rod would hold. Only set that I had that held up good was a set we polished peened and cryoed, those have held up for a couple years until i spun a bearing in one so I replaced it with one we just polished due to time constraints and it bent right away.
I wont put another 12v rod in a 6.7 from now on I am tired of replacing them. I have used some Carrillos and really like them, alot lighter then stock rods and a really nice piece.
Maybe he wants to make more than 700 hp I dunno. I just know what I would do but opinions are like ass holes,everyone has one. I just think yours stinks
The rod angle isn't a huge deal. Its not like its way different.If u do the research it is several rod failures that have happened.