Search results

  1. williamallen13

    S363 kit now has dtcs

    While I was sitting stopped in traffic this morning my truck had the advanced Stabilitrak pop up and then it says reduced engine power in I had to pull over immediately and so I check for the codes in the po132 a which is something with the turbocharger electrical fault or something. Has anyone...
  2. williamallen13

    Diesel Power Challenge 6.7's

    Anyone seen the 2 - 6.7's in the diesel power challenge this go around? What's with the stock turbo's, stock fueling, stock engine's, and stock transmissions?
  3. williamallen13

    Wot runs

    What's the best way for a wot run? I mean do I need to turn traction control off and do I literally push the accelerator all the way to the floor at once? I just don't want to break anything getting a wot test run for tuning.
  4. williamallen13

    MPD Kit S363 Turbo Surging

    Since installing the S363 turbo kit on my 2011 6.7 I've noticed at highway speeds like 65+ the truck seems to surge or slightly jerk forward when I let off the accelerator to coast. I've tried to ease off and it still does it a little and I would say it does it most of the time. Any suggestions...
  5. williamallen13

    MPD Budget Turbo kit install

    I have a 2011 f250 and the turbo recently started going out. Yesterday about 5 pm I took off the intake and upper and lower intake manifolds to check the play and sure enough it had some. So I decided to buy the MPD budget kit with the S363 turbo and a CCV Bypass kit. After talking with them...
  6. williamallen13

    Anyonw write custom SCT tunes?

    I am getting a 6.7 mpd budget turbo kit and need tuning for my d leted 2011 f250. I have a sct 3015 from Rudy's, anyone know where to get them?
  7. williamallen13

    How much shaft play is okay?

    I have a d-leted 2011 f250 with the stock turbo and I removed the intake and when I turned the blades the shaft has some play in it. I would say about 1 mm. It doesn't rub but has been making some weird noises lately and my performance has gone down lately. I swear I heard a tinking noise from...
  8. williamallen13

    Turbo seems to be making strange noise

    I have 2011 f250 160k, d-leted, original turbo and just noticed in the past couple weeks a lack in power and decrease in mpg. Today I checked the oil and noticed a strange tinking noise coming from the turbo. Not a squealing or whining but a noise similar to a tinking or pinging. Totally...
  9. williamallen13

    Is it safe to daily drive in extreme tune?

    I have a ******d 2011 f250 and want to know about the different tunes my sct race tuner came with. It cam with tow, street, street firm, performance, and extreme. When I first got the tuner I just kept it in performance and never really used the extreme. But here lately I've had it in extreme...
  10. williamallen13

    Repaired Splits in Console Cover

    I recently decided to replace the vinyl on my console since it had started splitting about a year ago. First thing was to pry the top of which isn't hard it just pops off. Then pull all the staples out that hold on the vinyl and pull it off. The stitching left indentations in the foam so at...
  11. williamallen13

    Finally sorted out lift and wheels

    I bought 20x12 fuel's with 35x12.5x20 Toyo MT and 4" taller springs, drop pitman arm, 5.5" rear blocks, drop radius arm brackets. I already had a pro comp 2.5" spacer kit that I took all off except the drop sway bar and drop track bar bracket. So the problem I had was all from the drop pitman...
  12. williamallen13

    Please help, installed new wheels now feeling a "death wobble"

    I have a 2011 f250 and I recently installed new 20x12 fuel wheels, 35x12.5x20 toyo mt, 4" springs, drop pitman arm, and drop radius brackets. Now when I get up to about 30 mph and hit any uneven pavement or bumps the front seems to want to wander back and forth. Has anyone who installed these...
  13. williamallen13

    Help with drop pitman arm

    Installed 4 inch lift and replaced pitman with drop pitman and now it hits the drop track bar bracket. I made sure to put drop pitman on at exact angle of stock pitman? Please help.
  14. williamallen13

    35's rubbing, any pic of trimmed front factory fender flares?

    I got the 20x 12 mavericks and 35x12.5x20 toyo M/T on my 2011 f250 and now they are rubbing with my current 2.5 front spacer lift. I have some 4" springs, a drop pitman, radius arm drop brackets, and 5.5" rear blocks coming but was wanting to see if anyone has pics of trimmed front fenders. I'm...
  15. williamallen13

    20x12 Fuel Mavericks & Toyo mt, any rubbing

    I have a 2.5" spacer lift and wanted to know if the 20x12 fuels and 35 x12.5 will rub the front fender? I do have an m1 front bumper.
  16. williamallen13

    Better rims, Fuel Mavericks or RBP Assassin??

    Anyone know about these 2 brands and wheels. I am looking to get new 20x10 wheels and want to know which are better?
  17. williamallen13

    35x12.5x18 trail grapplers on 12" wide rims?

    Does anyone know if the 35x12.5x18 trail grappler will fit a Fuel Maverick 18x12 rim with -44 backspacing on a 2011 f250 with a 3" lift? Nittos website says those tires will fit up to an 11" rim but I've seen other companies with similar sized tires fitting up to a 12" rim.
  18. williamallen13

    Fuel Pressure Gauge

    I have a 2011 6.7 and was going to buy a 3 pod pillar and was wanting to know which fuel pressure gauge do I need? 0-30 psi, 0-60psi, or 0100 psi?
  19. williamallen13

    1st power upgrade, fuel or turbo?

    After d-leet, intake, exhaust, what should be next for more power in a 2011 6.7? I still have the stock turbo but notice it seems to run out of fuel in the highest hp tune so should I be getting a duel fueler or upgraded turbo first? Which will make more hp because I will have to space the...
  20. williamallen13

    New ats aurora 4000 drop in

    Anyone installed the Aurora 4000 kit yet?

Latest posts

Members online

Top